Page 1 of 1

Single raise pre flop

PostPosted: Wed Apr 13, 2011 10:56 am
by andy2001
I'm trying to make a a stat show raises preflop that are open raises or vs limpers. I have

(cnt_p_raise_limpers+cnt_p_raise_first_in)/(cnt_p_open_opp+cnt_p_facing_limpers)*100

But when I use it it can't access opportunities on the hud.

Re: Single raise pre flop

PostPosted: Wed Apr 13, 2011 12:35 pm
by kraada
That looks like it should work fine to me - have you tried updating the cache?

Re: Single raise pre flop

PostPosted: Wed Apr 13, 2011 2:06 pm
by andy2001
Just tryed updating the cache and it's still the same. I thought the cache update was for when a new colum is added. This stat uses existing ones.
The numbers I'm getting look like they may be correct, just no samplesize given.

Or do I need to make two new colums for this stat.

Re: Single raise pre flop

PostPosted: Wed Apr 13, 2011 2:16 pm
by kraada
You shouldn't need new columns but I just thought I'd check.

Try restarting PT3 also and see if the stat comes up then.

Re: Single raise pre flop

PostPosted: Thu Apr 14, 2011 4:27 am
by WhiteRider
To see times/opportunities in the HUD the Value Expression needs to be in a specific format:

(a / b) * 100

Note exactly where the spaces are.
I think that it should work correctly when using +, but I'm not absolutely sure. Try an expression like this:

((cnt_p_raise_limpers+cnt_p_raise_first_in) / (cnt_p_open_opp+cnt_p_facing_limpers)) * 100